RSS FeedThe caulk can be loosened with help of utility knife between the bathroom vanity and the wall.
A step by step and careful approach to replace your worn out bathroom vanity can clean your bathroom in a short period. You require a day to complete this procedure. You can select bathroom vanity of your choice but you must be clear which one to buy.
Bathroom vanity should be replaced by following instructions. Firstly, disconnect the water supply use P-trap, the while curved pipe in the center. Keep buckets under the water supply to catch water dripping out of the water pipe.
Bathroom vanity can be removed by loosening caulk between vanity and wall a utility knife. Go down to the floor, even on sides to remove the caulk. Do not damage the wall. Remove counter top carefully and take help if the countertop is large enough use a screwdriver and remove the screws that attach the bathroom vanity with the wall now you can remove the old vanity.
Mark new screw holes and before this locate the wall studs. The new marks should be little higher than the new vanity's top. A cordless screwdriver will make your steps easy. New bathroom vanity should be flushed against the wall. Measure the new vanity with carpenter's level and shims. Then attach the bathroom vanity with 2.5 inch wallboard screws.
Install a new faucet so that you don't have to go under the sink once more and will make the job faster. To attach the bathroom vanity top to the lose use tub-and-tile caulk. Replace p-trap by reconnecting the plumbing use Teflon tope for easy and tight connection.
Tidiness is important parameter here to give you best results for the job done by you so apply thin line of caulk very carefully around the countertop edges.
Posted in 
Tags: